900 L4-1985cc 2.0L DOHC Turbo EFI (1985)
6.
Leaving the hose in place, remove a 2 cm (3/4 in.) section from the upper heater hose starting 18 cm (7 in.) from the end as shown in Figure 3.
Figure 4. Installing the "T" piece into the upper hose.
7.
Slide two of the larger hose clamps supplied in the kit onto each side of the upper hose and insert the "T" connector between the two hose
pieces as shown in Figure 4.
Figure 5. Attaching the lower coolant hose to the "T."
8.
Slide another large hose clamp onto the remaining portion of the lower hose and insert the hose onto the nipple of the "T" connectors as
shown in Figure 5.
Figure 6. Installing the mounting bracket on the pump.
9.
Press the mounting bracket onto the circulation pump as illustrated in Figure 6 (if necessary, use silicone to ease installation). Press the
bushing into the hole on the mouriting bracket.
