900 L4-1985cc 2.0L DOHC Turbo EFI (1985)
Figure 1
6.
Cut the wiring harness to the cruise control switch as close to the connector as possible (Figure 1). Remove the switch.
Figure 2
7.
Strip the ends of the wires in the harness and fit the four (4) pins. For proper connection, use crimping pliers, P/N 88 18 999. Fit the wires into the
4-pin connector, P/N 91 23 555, as shown in Figure 2.
Figure 3
8.
Remove the cruise control relay from the firewall and disconnect the connector. Fit the splice connector between wire 607 GN (green) and 602
RD/ VT (red/white) as shown in Figure 3.
9.
Secure the connector to the wiring harness with a tie strap or tape. Do not reconnect or install the relay.
10.
Install the new cruise control switch on the bracket and connect the cruise control and signal switch wires.