900 L4-1985cc 2.0L DOHC Turbo EFI (1985)
2.
Insert the input shaft so that it engages with the disc splines and flywheel bearing. Tap the input shaft until it is locked in place by the snap ring in
the primary shaft pinion, Figure 12.
3.
Install the six pressure plate bolts securing the pressure plate to the flywheel and torque to 23-28 N-m (17-21 ft.lbs.) Figure 13.
4.
Apply loc-tite to the slave cylinder retaining bolts. Rotate tool 87 92 020 as the bolts are installed. (Slide the tool against the pressure plate to
facilitate insertion of the socket cap screws), Figure 14.
5.
Screw the plastic propeller into the end of the input shaft.