900 L4-1985cc 2.0L DOHC Turbo EFI (1985)
10. Remove the needle bearing circlip and use a drift to tap the needle bearing out of the primary chaincase.
11. Use a screwdriver to remove the clutch shaft seal.
To Assemble
1. Fit a new clutch shaft seal, using tool 83 91 997.
2. Fit the needle bearing and its circlip into the primary chaincase. Make sure that the marking of the needle bearing faces outwards. Use tool 83 91
997.
3. Press the ball bearing onto the gearbox input shaft and fit its circlip. Use sleeve 83 90 148 and ring 87 90 867.
4. Press the input shaft with bearing into the primary chaincase.
NOTE: Preheat the primary chaincase so that the bearing will not be damaged when it is pressed in.
