900 L4-1985cc 2.0L SOHC (1988)
FIGURE 6 - FITTING THE WIRE LEADS.
8.
Install the terminal with the two black wires into the connector block as shown in Figure 6.
FIGURE 7 - REFITTING THE PIN INSULATOR STRIPS.
9.
Install the pin insulator strips in the connector (Figure 7). Push the connector block inside the cover and secure the connector block with its screw.
Slide the rubber boot into position and secure with a cable tie. Install the rubber seal.
10.
Plug the connector into the control unit for the EZK system and bolt the control unit bracket to the fender.
11.
Reinstall the bottom hose on the AIC valve.
12.
Reconnect the battery.
13.
Test drive the car and ensure that the EZK system is functioning properly.
Warranty Information:
For warranty claims, use Failure Coding 37130-63-0- 01-05. Labor allowance is 0.8 hour in straight time.
