900 L4-1985cc 2.0L SOHC (1988)
Constant Velocity Joint: Service and Repair
Axle Shaft and CV Boots
To Dismantle
Note: Take care to remove all dirt and dust particles.
1
Undo the clip and slide the rubber gaiter on the CV joint back along the shaft.
Mount the shaft in a press and compress the two spring washers to allow the circlip inside the hub to move in its groove.
2
Open the circlip and release the force applied by the press.
3
Withdraw the drive shaft from the hub, complete with the spherical washer, the two spring washers and the circlip on the shaft.
The hub cirdip should remain in its groove in the hub.
Note: The spherical washer, spring washers, circup and circlip groove were discontinued as from the following chassis nos.:
