900 L4-2118cc 2.1L DOHC (1992)
This spacer should be installed and the top adjusted on new cars before these are sold, and on cars that are returned for normal service.
Before fitting the spacers, verify that all modifications as described in S.I. 09/88-1076 (Service Campaign 513 found in Bound Supplement 7A, Sec. A-8,
p. 109) and S.I. 06/90-0011 with regard to down position limit stop have been carried out. These modifications are designed to minimize top fabric wear
and should be performed if they have not been previously done:
^
1986, 1987: top latches replaced? Top correctly adjusted?
^
1988 J7000001-J7006586: top latches replaced? Top correctly adjusted?
^
1988 J7006587-J7024537: Top adjusted correctly?
NOTE:
Although VIN ranges were given for Factory production start of modifications, you must verify that they have indeed been performed before proceeding
further.
3.
Remove any burrs or rough edges on the outside of the eccentric bolt (Figure 4).
4.
Lower the top three-quarters of the way down.
5.
Loosen the retaining bolts for the top lowering stop on both sides (Figure 5).
