900 L4-2118cc 2.1L DOHC (1992)
17. Fit the chain tensioner as follows:
-
Prepare the chain tensioner for mounting by pressing down the ratchet and pressing in the plunger.
-
Fit the chain tensioner and seal. Tighten to a torque of 63 Nm (47 ft lb).
-
Place the spring and locating stud (plastic) in the hole in the chain tensioner.
-
Fit the plug. Check that the O-ring is in place. Tighten the plug to 22 Nm (16 ft lb). As the plug is being tightened, the spring presses out the
tensioning arm and causes the chain to be tensioned (See Figure 10).
18. Replace the torque stay. Turn the engine over one revolution and check to see that the crankshaft and camshaft are lined up with respective timing
marks.
19. Fit the camshaft cover, spark plugs and ignition discharge module (if previously removed).
20. Reconnect battery terminals.
