900 L4-2118cc 2.1L DOHC (1992)
Constant Velocity Joint Boot: Service and Repair
Outboard
TO REPLACE CV-JOINT GAITERS
Note: Take care to remove all dirt and dust particles.
1
Remove the CV joint. See: Axle Shaft/Service and Repair
2
Undo the clips and remove the gaiter from the shaft.
Note: Remove clips of the non-screw type using pliers or similar as shown. Take care not to damage the rubber.
3
Fit a new gaiter.
Tighten the clips: if you are fiffing new clips of the non-screw type, fit them as shown in the adjacent picture.