900 L4-2118cc 2.1L DOHC (1992)
1. Use tool 87 91 964 and drift 83 90 189 to press the outer race of the taper roller bearing into the bearing housing nearest to the pinion. Use sleeve
87 90 461 and drift 83 90 189 for the outer race of the other bearing.
2. Press the roller bearing nearest to the pinion as far as it will go. Use fixture 87 90 636 and fitting ring 87 91 972.
3. Fit a new spacer to the shaft.
4. Fit the bearing housing.
5. Fit the front roller bearing.
6. Set up the shaft in the press (see figure). Use fixture 87 90 636 and fitting ring 87 91 972 and press slowly, at the same time turning the bearing
housing. Continue pressing until resistance is felt.
