9000 L4-1985cc 2.0L DOHC (1986)
2.
Cut (see 2-A) and bend (2-B) the bracket as shown in Figure 3.
3.
Bracket holes should be marked on the new inner wheel housing as indicated in Figure 3-3.
4.
Position the bracket according to the markings made in step 3. Using a 4 mm bit, drill 3 holes in the inner wheel housing, using the bracket as
a template.
5.
Install the bracket after the car has been treated for ant-corrosion and painted.
2.
Door Frames and Outer Sills:
The following steps must be taken when installing a replacement door frame on 1990 and earlier 9000's:
a.
Drill the seat belt anchor point out of the reinforcement on the car. See Figure 4-1.
b.
Cut off the three flanges on the new door frame so that it can be mated to the reinforcement on the car body. See Figure 4-2.
c.
Using a high quaiity product, prime all ground metal surfaces.
NOTE:
The seat belt anchor points are included in the new door frames.
