9000 L4-1985cc 2.0L DOHC (1986)
the lead from pin 3 of the connector to pin 1 of the position switch (203) and the lead between pin 2 of the position switch and ground.
LH 2.4 and LH 2.4.1
the lead between pin 2 of the connector and pin 1 of the position switch (203) and the lead between pin 2 of the position switch and ground.
6 Connect the multimeter to:
LH 2.2
pin 12 and ground
LH 2.4 and LH 2.4.1
pin 3 and ground
If the position switch is in proper working order the circuit should close when the throttle butterfly is rotated through 720, i.e. near the wide open
throttle position.
7 If this does not happen, check:
LH 2.2
the lead between pin 12 of the connector and pin 3 of the position switch (203)
LH 2.4, 2.4.1
the lead between pin 3 of the connector and pin 3 of the position switch (203).
If the wiring is OK but the position switch does not work properly, change the position switch.