saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Fuel Injector - Contamination Detection|Page 2302 > < Engine - Stalling/Poor Starting/Loss of Power|Page 2297
Page 1
background image

Technical Service Bulletin # 1086902

Date: 861001

Fuel Injector - Contamination Detection

FILE IN S.I. Man  VOL. I

SEC. B-2  PG. 4
Service Information

SUBJECT:

ON CAR TESTING AND CLEANING                        ISSUE: 10/86-902 ELECTRONIC FUEL INJECTORS

APPLICATION: 9000 MODELS

Insufficient detergent gasolines may cause injector contamination (fouling). Stalling, poor starting, rough idle or loss of power complaints may be an
indication of dirty or clogged fuel injectors.

This Service Information contains instructions for detecting contaminated fuel injectors (see Fuel Injector Balance Test) and cleaning them if necessary
using the Saab Fuel Injector Cleaner/Tester. Read these instructions carefully before proceeding.

Warning! The gasoline and cleaning solution used in this system are extremely flammable and is pressurized during the operation. Have a Class B fire
extinguisher handy and keep all solutions away from flame, heaters or machinery which may produce sparks.

A Fuel Injector Balance Test must first be performed before any cleaning takes place. Prior to checking injectors, remember that the timing, pulse
relation, compression, dashpot and throttle switch settings must be correctly set.

Notice:

To use this device the vehicle fuel system must hold pressure (fuel pressure regulator and fuel pump check valve must be functioning
properly). If it does not hold pressure, correct as necessary before proceeding.

Saab Injector Cleaner/Tester

P/N 83-94-264

NO SMOKING

Access Fitting * (900 Models)

P/N 83-94-280

CAUTION: CONTENTS

Access Fitting * (9000 Models)

P/N 83-94-298

UNDER PRESSURE

Liquid Fuel Injector Cleaner

P/N 83-94-272

(Case of 12 cans)

*

Contained in 83-94-264

A.Fuel Injector Balance Test

1A.

Depressurize cleaner tank via the pressure relief pull ring.

2A.

Remove the pump and cap assembly from the cleaner/tester tank.

3A.

Wear eye protection. Attach access fitting assembly to fuel pressure line at
fuel rail inlet using the existing seals. Wrap a shop rag around inlet of fuel rail to prevent and absorb gasoline spray.

Fuel Injector - Contamination Detection|Page 2302 > < Engine - Stalling/Poor Starting/Loss of Power|Page 2297