Insufficient Clearance: A/T Oil Cooler Hose for 9000 L4-1985cc 20L DOHC (1986)
Transmission Cooler: All Technical Service Bulletins
A/T Oil Cooler Hose - Insufficient Clearance
FILE IN S.I. Man
VOL. I
SEC. A-2
PG. 189
Service Information
SUBJECT:
INSUFFICIENT OIL HOSE CLEARANCE ISSUE: 12/85-809
APPLICATION: EARLY 1986 900, 900S EQUIPPED WITH AUTOMATIC TRANSMISSION
The hydraulic oil hose for the automatic transmission oil cooler may be routed too close to the AC radiator fan support. Please see the following
directions for correcting this problem. Cars built after the VIN Serial Nos. listed below have been checked and corrected on the assembly line.
Affected cars should be checked during the P.D.I. or at the next scheduled service.
Cars Affected:
900, 900S
G2000001 - G2002513 G3000001 - G3001929 G7000001 - G7004206
FIGURE 1
Checking and Repair Instructions:
1.
Check the clearance between the hydraulic hose (P/N 75-43-700) and the AC fan support.
If the clearance is less than 1/8" (3 mm) proceed with the following repair steps until proper clearance is achieved.
2.
Move clamp (P/N 71-55-500) to the new position as indicated in fig. 1. Fit a tie-strap (P/N 79-71-872) as shown.
Check the clearance. If inadequate proceed to step 3.
