saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 4269 > < Diagram Information and Instructions|Page 4267
Page 3
background image

54

Door switch for the interior lighting
At the front of the driver's door frame, between the hinges

57

Three-pole connector
Under the co-driver's seat

59

Two-pole connector (1988)
At the left-hand A-pillar

60

Single-pole connector (1987)
At the left-hand A-pillar

65

Earthing point
Under the back seat

69

Seat switch for the co-driver's seat-belt warning lamp
Under the co-driver's seat

70

Seat-belt switch for the driver
Between the front seats

71

Seat-belt switch for the co-driver
Between the front seats

72

Seat-belt warning lamp
In the roof console, above the inner rear view mirror

82

Seat-belt/ignition switch warning relay
In the electrical distribution box behind the glove compartment

122

Eight-pole connector
One under the facia, to the extreme left (behind the knee shield)
One under the driver's seat
One under the co-driver's seat

158

Negative distribution terminal
In the electrical distribution box behind the glove compartment

159

Distribution terminal +15
In the electrical distribution box behind the glove compartment

224

Seat-belt lock illumination
In the seat-belt locks, between the front seats

231

Distribution terminal +54
In the electrical distribution box behind the glove compartment

341

Earthing point
On the left-hand front seat member

Operation

The seat-belt and ignition key warning system is fitted only on cars for USA, Canada and Japan.

The warning system reminds the driver that he has not fastened his seat belt, or that the key is still in the ignition switch when he leaves the car.

The system includes warning relay 82, which has a built-in buzzer. When the ignition switch is in the drive position, terminal 15 on the relay will be
connected to supply +15 across fuse 13.

Seat-belt warning

When the ignition switch is in the drive position, the warning relay is also supplied (+54) from fuse 3, via seat-belt warning lamp 72.

If the seat belt is not fastened, terminal GF of the relay will be earthed by driver's seat-belt switch 70. The warning lamp will then light up and the
buzzer will sound. When the seat-belt buckle is inserted into the lock, the switch will open and the lamp will be extinguished.

Ignition-key warning

Diagram Information and Instructions|Page 4269 > < Diagram Information and Instructions|Page 4267