9000 L4-1985cc 2.0L DOHC Turbo EFI (1987)
INSTALLATION
1. Check the axle stud for possible damage. Fit the hub by gripping the it with both hands and pressing against the outer bearing race with your
thumbs. Guide the hub on to the stub axle, feeling to make sure it goes on straight. Carefully push the hub into position.
2. Fit a new hub center nut and dust cover.
Tightening torque: 290 Nm (214 ft. lbs.)
IMPORTANT: New hub center nuts should always be fitted if the hub center nuts have been loosened, because its clamping force is reduced
after the nut has been slackened.
3. Fit the brake disc and locating stud.
4. Fit the brake unit and the hand brake cable, and if necessary the ABS sensor (installation of ABS sensor to and including M1989.
5. Adjust the brake piston and fit the screw plug.
6. Replace the wheel and lower the car.
7. Tighten the wheel studs to 120 Nm (89 ft. lbs.)
