9000 L4-1985cc 20L DOHC Turbo EFI (1987) Valve Body - Service and Repair
5. Install the separator plate.
NOTE: Remember that the separator plate must not be lifted when it is on the valve body.
6. Install the upper part of the valve body and lightly tighten the four screws.
7. Install gasket and cover and lightly tighten the five screws.
8. Check that the parts of the valve body are directly above each other and then torque tighten all screws.
NOTE: Start with the screw in the center and then tighten the other screws around, finishing with the screws along the outer edges.
a. Screws, accumulator housing.
Tightening torque: 6 Nm (4 ft. lbs.)
b. Screws, small cover on upper part of valve body.
Tightening torque: 6 Nm (4 ft. lbs.)
c. Screws, cover.
Tightening torque: 6 Nm (4 ft. lbs.)
d. Screws, upper part of valve body.
Tightening torque: 6 Nm (4 ft. lbs.)
9. Install the complete valve body to the transmission.
CAUTION: If there was dirt in the valve body, flushing equipment tool No. 87 91 824, or equivalent, should be connected to the transmission cooling
system before starting the engine.
