9000 L4-1985cc 2.0L DOHC Turbo EFI (1987)
7. Fit the brake disc, locating stud and bolt.
8. Fit the brake unit and install the flexible hose in its mounting on the MacPherson strut. If necessary, fit the ABS sensor.
Tightening torque for brake unit securing bolts: 90 Nm (66 ft. lbs.)
9. Fit a new hub center nut.
IMPORTANT: New hub center nuts should always be fitted if the nut has been unfastened, because the clamping force of the locking device is
reduced after re-fitting.
10. Replace the wheel and lower the car. Tighten the wheel nuts.
Tightening torques for the wheel studs: 120 Nm (89 ft. lbs.)
11. Tighten the hub center nut.
Tightening torque for hub center nut: 290 Nm (214 ft. lbs.)
IMPORTANT: Press out the brake pads with the brake pedal. The glue (Loctite 641) should be allowed to dry for 1 hour before the car is driven.
