9000 L4-2290cc 2.3L DOHC Turbo EFI (1992)
Action:
Installing steel lever:
1.
Switch the ignition on.
2.
Select "LO" on the ACC unit.
3.
Switch the ignition off.
4.
Remove the cover from the bulkhead partition space.
5.
Disconnect the cable from the damaged part of the lever.
6.
Slip on the lever. See Figure 2-D.
7.
Fix the steel lever by pressing in the locking tongue. Figure 2-E.
8.
Refit the cable and press the clip in place.
9.
Refit the cover on the bulkhead partition space.
10.
Remove the ACC control module from the dash.
11.
Slip rubber bushing P/N 43 82 826 onto the rear limit stop of lever. See Figure 2-B.
12.
Position the ACC control module in the dash.
13.
Calibrate the ACC control module by switching on the ignition and then pressing "AUTO and "VENT" at the same time.
