9000 L4-2290cc 2.3L DOHC Turbo EFI (1992)
INSTALLATION
1. Clean and de-grease the drive shaft and hub.
2. Unfasten the two steering swivel member bolts from the spring. Move the steering swivel member out of the way so it is possible to tighten the hub
securing bolt.
3. Re-fit the disc back-plate and hub.
4. Tighten the four bolts securing the hub to the steering swivel member.
Tightening torque: 57 Nm (42 ft. lbs.)
5. Apply Loctite 641 approximately. 10 mm in and around the spline joint on the shaft, see picture.
6. Hold the outboard universal joint and fit the spline joint on the shaft in the hub and re-fit the two steering swivel member bolts to the MacPherson
strut. The nuts should sit forwards. Use new nuts.
Tightening torque: 91 Nm (67 ft. lbs.)
