9000 L4-2290cc 2.3L DOHC Turbo EFI (1992)
Ignition Control Module: Service and Repair
Ignition Discharge Module, Spring Replacement
Ignition discharge module, spring replacement
To check
Check that the springs are intact and in position.
To remove
1 Unplug the ignition discharge modules 1O-pin connector.
2 Remove the ignition discharge modules 4 retaining bolts from the cylinder head.
3 Lift up the ignition discharge module.
4 Turn the ignition discharge module upside down and remove the 8 bolts.
5 Lift off the black bottom part of the ignition discharge module.
6 Use a screwdriver to pry out the old spring.
To fit
1 Fit a new spring.
2 Fit in reverse order.
Tightening torque: 4 bolts on ignition discharge module 11 Nm (8 lbf ft)