9000 L4-2290cc 2.3L DOHC Turbo EFI (1992)
Oxygen Sensor: Service and Repair
Replacement
Oxygen sensor (turbo engine)
Removal
Important: The electrical connector may be located either under the cover panel over the false bulkhead space or under the intake manifold.
1 Remove the cover panel.
2 Unplug the oxygen sensor connector.
3 Withdraw the oxygen sensor's leads. To do this, it may be necessary to raise the A/C pipes slightly.
4 Remove the clamps securing the oxygen sensor 5 lead to the coolant pipe.
5 Remove the clamp adjacent to the A/C compressors lower retaining bolt.
6 Remove the oxygen sensor.
Important: The leads must not be twisted. The oxygen sensor is sensitive to impacts and jolts and should therefore be handled with care.
Fitting