9000 L4-2290cc 2.3L DOHC Turbo EFI (1992)
Crankshaft Position Sensor: Service and Repair
Crankshaft position sensor
To remove
1 Switch off the ignition.
2 Fit special tool 83 93 993 to lock the flywheel.
3 Remove the right-hand front wing liner.
4 Compress the belt tensioner and lock it using yoke 83 95 488.
5 Remove the A/C belt. Undo the nut and bolt on the belt tensioner. Remove the generator belt.
6 Remove the pulley.
Important: This will be easier if it is carefully heated.
7 Remove the crankshaft position sensor.
8 Unplug the connector and remove the cable tie.
To fit
Fit in reverse order.
Important: The crankshaft position sensor's retaining bolts should be fixed with LOCTITE type 270 or other suitable locking fluid.
Belt pulley tightening torque 190 Nm (140 lbf ft)