9000 L4-2290cc 2.3L DOHC Turbo EFI (1992)
Control Arm: Service and Repair
Front Suspension
Fig. 5 Front Suspension
Fig. 6 Exploded View Of Lower Control Arm Assembly
1.
Raise and support vehicle, then remove wheel.
2.
Remove nut securing sway bar link to control arm, Fig. 5, then remove upper securing bolt for sway bar link.
3.
Press down on control arm and remove sway bar link.
4.
Remove two nuts at front of control arm securing arm to frame.
5.
Remove two rear bolts securing reinforcement member to frame.
6.
Remove two bolts securing control arm rear pivot to frame, then remove control arm.
7.
Reverse procedure to install, noting the following:
a. To facilitate installation of control arm, leave nuts for bushing in rear pivot loose until arm is installed, Fig. 6..
8.
Road test vehicle, then check alignment.
