9000 Aero L4-2290cc 2.3L DOHC Turbo EFI (1996)
To Install
9
Check that the compressor belt tensioner is in position and that the belt is correctly positioned on the engine's pulley.
10
Install the belt tensioner. Reinstall the rest of the retaining screws without tightening them.
Important : Screws must be tightened in the following order to avoid damage to the compressor securing tabs and bracket.
Start by tightening the two screws on the front edge of the compressor to 20 Nm (14.8 lbf ft). See drawing. Then tighten the two screws in the rear edge
of the compressor to 20 Nm (14.8 lbf ft).
Tighten the two remaining screws to 39 Nm. (28.8 lbf ft)
11
Install the drive belt and tension as below. Use a tensiometer.
When reinstallation belt:
Tighten to 80 ± 5 lb (355 ± 22 N)
When lifting new belt:
Tighten to 120 ± 10 lb (535 ± 45 N)
When checking belt tension
If belt tension is below 60 lb (265 N), it is recommended that the belt be tensioned to 80 ± 5 lb (355 ± 22 N)
12
Install the plastic cover over the right-hand headlamp.
