9000 Aero L4-2290cc 2.3L DOHC Turbo EFI (1996)
2. Tape the cable assembly in the air duct above the SRS control module.
Steering Wheel Airbag
3. Run the steering wheel airbag wiring (one red and one orange lead) to the orange connector by the steering shaft. Plug in the connector.
4. Tie the wiring with cable ties. Where possible, tie to existing wiring.
WARNING: The leads must not come into contact with moving parts like the steering column.
Belt Tensioner, Driver Side
5. Run the belt tensioner wiring against the door on the driver side (one brown and one blue lead).
6. Tie the wiring to the air duct over the pedal bracket using cable ties.
7. Run the wiring from the outer part of the air duct to the existing wiring harness by the wheel housing.
Run the new wiring in the cable channel together with existing wiring.
8. Undo the bolt securing the belt roller and belt tensioner.
9. Run the wiring behind the belt tensioner together with existing wiring.
10. Plug in the connector to the belt tensioner.
11. Tie the wiring to existing wiring using cable ties.
WARNING: The wiring must not come into contact with moving parts like the belt tensioner and belt.
Airbag, Passenger Side (Only if the car is fitted with passenger airbag).
12. Run the passenger airbag wiring (one gray and one violet lead) to the connector from the existing passenger airbag. Plug in the connector.
13. Tie the leads with cable ties so that they cannot rattle.
