9000 Aero L4-2290cc 2.3L DOHC Turbo EFI (1996)
Suspension Arm: Service and Repair
Suspension Arm and Bearings (Removal)
REMOVAL
Suspension Arm
1. Lift the car. If a jack is used the car must be supported on axle stands.
2. Remove the wheel.
3. Remove the three bolts securing the suspension arm to the ball joint.
4. Remove the nut securing the suspension arm to the anti-roll bar link (A). Slacken, without removing, the nut securing the anti-roll bar (B).
5. Push the steering swivel member out of the way. Push down the suspension arm and withdraw the anti-roll bar link.
6. Take the weight of the suspension arm by resting the arm on the ball joint.
7. Remove the two nuts at the front securing the suspension arm to the subframe. Push out the bolts as far as possible towards the engine.
8. Undo the four bolts (A) securing the reinforcement plate and remove the plate.
9. Lever the suspension arm towards the steering swivel member and lift it down and off.
