9000 Aero L4-2290cc 2.3L DOHC Turbo EFI HO (1997)
26. Install millimeter disc tool No. 87 92 061 on the output shaft's nut.
-
Mark up one tooth on the gear wheel with a felt tip pen or similar.
-
Set the millimeter disc tool's scale to the calculated value (measured + nominal, see example).
27. Tighten in 2-3 stages until the millimeter disc tool's zero reading (O) is opposite the marked tooth.
-
Upset the nut collar in three places on the fifth gear wheel to lock the nut.
-
Remove millimeter disc tool and sleeve.
28. Lift off the fifth gear's pinion, synchromesh, synchromesh hub and sleeve.
-
It might be necessary to use a puller to remove the hub.