9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Control Assembly: Service and Repair
Control Panel, Changing
1
Fully lower the glove compartment flap by bending out the ink arms so that the stops are released. Pull down glove compartment light.
2
Remove the glove compartment together with the facia vent by undoing the six screws. Using a screwdriver, carefully prise along the edge of the
facia vent. Note position of clip. Detach cables from glove compartment lamp and the lighting switch.
Cars equipped with passenger airbag:
Remove the upper part of the facia. On right-hand drive cars, the main instrument must also be lifted out.
3
Undo electrical distribution box and lift down.
4
Remove the ashtray.
5
Pull the ashtray holder forward by bending down the two upper locking tabs.
6
Detach the control panel by pressing in the four retaining lugs and pulling it into the cabin.
7
Detach
The air distributor rod
The temperature valve gear, making sure that the temperature control is set to position 0.
All connectors
8
Plug in all connectors to the new control panel.