9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
/Page-995002.png)
Removal
-
Remove sealing ring and tap out the bearing bush with driver tool No. 87 91 220, or equivalent.
Installation
-
Install a new bearing bush with driver tool.
Differential Bearing Race
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Removal
1. Remove the four screws of the seal holder.
-
Lift out the screws and the seal holder and remove the O-ring.
2. Carefully tap out the bearing race with a hammer and a drift (destructive dismantling).
CAUTION: Tap equally on both sides
