9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
10. Make sure that the pinion is turned the right way, press on a new bearing next to the 4th gear's pinion.
-
Use screw press 87 91 261.
-
Install a new locking ring WITH THE BEVELLED EDGE FACING UPWARDS.
CAUTION:
^
Open the locking ring carefully before installing just enough to be able to install it on the shaft.
^
If the locking ring is opened too much, it will be damaged.
-
Carefully tap the locking ring into the grove of the shaft with a drift.
11. To check that the input shaft is correctly installed, check the play between the bearing and the 4th gear's pinion.
-
The play should be 0.05-0.40 mm