9000 CDE V6-2962cc 3.0L DOHC (B308) (1995)
Shifter M/T: Service and Repair
Gear Lever Knob
Removal
1. Remove the gear lever.
2. Secure the gear lever in a vice.
3. Apply tape around the driver, directly below the knob, so that the driver is not damaged or scratched when it is removed.
4. Place a 32 mm open ended wrench under the edge of the knob.
-
Carefully tap with a plastic hammer on the key from below.
-
Lift out knob and driver.
5. Remove the tape.
-
Remove the knob from the driver by pressing in the three plastic hooks on the driver with a small screwdriver.
-
(The hooks are accessible under figures 1, 5 and 4 on the knob.)
-
Note the steel spring below the knob.
NOTE: A removed gear lever knob must not be installed again, but changed for a new.