9000 CS L4-2290cc 2.3L DOHC Turbo EFI (1996)
-
Tighten to: 27 Nm (20 ft lb)
2. Reconnect the brake pipes and tighten the connections.
3. Reconnect the hoses from the brake fluid reservoir.
-
Take care to ensure that the sealing rings are not pressed out of position.
4. Fill up with brake fluid, DOT 4 specification.
5. Bleed the brake system.
6. Reinstall the fuel filter.
-
(Not model year 1990 and later cars.)
7. Put the, battery back in place and reconnect the cables.
Overhaul
Disassembly
1. Clamp the master cylinder in a vice installed with soft jaws.
2. Remove the rubber seals from the brake hose connections.
3. Press in the primary piston (nearest the bulkhead partition) and remove the secondary piston's stop pin.
4. Remove the pistons and plastic sleeves from the cylinder bore.
5. Inspect the parts and replace any that are damaged.
-
Also check that the cylinder bore is not scored.
Assembly
