9000 CS L4-2290cc 2.3L DOHC Turbo EFI (1996)
3
Compressor SD 510:
Tighten the three screws.
Compressor SD 709:
Install the circlip.
4
Install the clip and screw for the cable.
5
Place the rotor section on the compressor. Place the presser and intermediate ring 83 93 407 (set) for SD 510 or 8292559 for SD 709 in the rotor
section. Note that the intermediate ring is oriented so that the compressive force is exerted on the inner ring bearing. Tap down the rotor section
using a hammer until it stops against the compressor housing.
6
Install circlips for bearing and rotor.
7
Install key.
8
Place the compressor clutch driver on the shaft. Install adapter 8393415. Tap down the driver using a hammer so that it stops against the shims on
the shaft.
9
Install the center nut.
Tightening torque 38 Nm (28.2 lbf ft).
10
Check the play between the driver and rotor.
Play should be between 0.40 - 0.80 mm. (0.16"- 0.31").
If play is not correct, remove the driver and adjust the number of shims.
