9000 CS L4-2290cc 2.3L DOHC Turbo EFI (1996)
Output Shaft: Service and Repair
Overhaul
Shaft
Disassembly
-
When the circlip has been removed, the annulus can be removed from the output shaft.
Bearing
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Removal
NOTE: The transmission must be dismantled up to the output shaft.
1. Remove the tapered bearing from the output shaft drive. Use puller ring tool No. 87 91 691, screwed into puller tool No. 87 91 642 with support
tool No. 89 95 177 as a holder, or equivalents.
2. Remove the tapered bearing from the output shaft.
Use puller and puller ring tool with drift tool No. 87 91 410 as a holder, or equivalents.