9000 CS L4-2290cc 2.3L DOHC Turbo EFI (1996)
Installation
1. Mark 1.5-2.5 mm up from the edge on driver tool.
2. Press in the sealing ring to the marking.
3. Press in a new bearing with tools press plates (two halves) and driver tool.
4. Press the bearing on to the universal joint drive with tool press drift tool.
5. Install the lock ring.
6. Lubricate and carefully install a new O-ring.
7. Make sure the plunger is in position.
8. Carefully tap in the universal joint drive so that the O- ring is not damaged.
9. Install the five securing screws and tighten.
Tightening torque: 20-28 Nm (15-21 ft. lbs.)
Inner Actuator Shaft (Output Shaft), RH Side
NOTE:
^
Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
^
When you remove the inner universal joint drive shaft in a car, first remove the intermediate shaft.
