9000 CS L4-2290cc 2.3L DOHC Turbo EFI (1996)
7. Place all springs and plungers in a safe place.
8. Remove the locking ring that holds the synchromesh hub.
-
Remove the hub.
9. Lift out the 3rd gear's synchromesh, gearing and needle bearing.
10. Check the condition of all parts as regards wear.
-
Replace damaged or defective parts.
-
Measure the wear on the synchromesh by installing it in its place.
-
Measure with a feeler gauge in three places between the baulk ring and the pinion and calculate a mean value.
-
New synchromesh 0.8-1.1 mm
-
Minimum measurement 0.5 mm.
-
Less = worn out; replace synchromesh.
Assembly
NOTE: Oil all parts with suitable 10W30 engine oil before installing.
1. Install input shaft in a screw vice with protective jaw faces.