9000 CSE L4-2290cc 2.3L DOHC Turbo EFI (1995)
Vacuum Brake Booster: Service and Repair
With Mark IV ABS System
Removal
1. Remove the Antilock Brake System (ABS) hydraulic unit.
2. Remove the lower section of the dashboard adjacent to the pedal assembly by pressing in the 4 mm locking pin on the five plastic clips.
3. Remove the clips and clevis pin from the pushrod.
4. Undo the four retaining nuts securing the vacuum servo.
5. Disconnect the vacuum hose and unplug the pedal position sensor connector from the vacuum servo.
6. Lift out the vacuum servo unit.
7. When changing the vacuum servo unit, the pedal position sensor should be transferred to the vacuum servo.
-
The adjusting sleeve having the same colour as the colour marking on the vacuum servo unit should be mounted on the pedal position sensor.
Installation