9000 CSE V6-2962cc 3.0L DOHC (B308) (1996)
Knock Sensor: Service and Repair
Front Knock Sensor
To Remove
1. Remove the engine covers.
2. Unplug the sensor's connector.
Before removing the wiring, note how the leads are run and where the cable ties, if any, are located.
3. Remove the clips securing the wiring.
4. Remove the sensor retaining bolt.
5. Remove the knock sensor.
To Fit
Before refitting, thoroughly clean the surface of the sensor that is in contact with the engine block.
Tightening torque: 22 Nm (16 ft lbs).
Fit in reverse order.
Make sure the wiring is correctly positioned and fastened in place.