9000 CSE V6-2962cc 3.0L DOHC (B308) (1996)
Output Shaft: Service and Repair
Bearing
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
REMOVE
-
Push out the bearing with puller ring tool No. 87 92 178 (20 teeth), 87 92 004 (21 teeth) or 87 92 160 (23 teeth) and mother tool fixture tool No.
87 90 636, or equivalent.
INSTALL
-
Press on a new bearing until it reaches the bottom, using tools sleeve ring tool No. 87 92 202 and sleeve tube tool No. 87 91 204, or equivalents.