9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
Brake Bleeding: Service and Repair
With Mark II ABS System
Brake Circuits, Front Wheels
A brake system bleeder unit can be used for the front wheel brake circuits.
1. Top up with brake fluid, DOT 4 specification, as necessary.
2. Connect a length of transparent plastic tubing to the bleed nipple on the right-hand front wheel brake caliper.
-
Place the other end of the tubing in a suitable receptacle.
3. Get a helper to depress the brake pedal at the same time as you open the bleed nipple.
-
Close the nipple when the brake pedal is fully depressed and then tell the helper to release the pedal.
-
Repeat this procedure until the brake fluid in the transparent hose is free from air bubbles.
-
To bleed the other brake circuit for the left-hand front wheel. repeat points 2 and 3.
Brake Circuit, Rear Wheels