9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
1. Get a helper to hold the pedal assembly so that its holes and the holes in the bulkhead partition are in alignment when the vacuum servo is installed
in place.
2. Screw on the four vacuum servo retaining nuts and tighten them.
-
Tighten to: 15.5 Nm (11.5 ft lb)
3. Install the clevis pin and clip on the pushrod.
4. Install the lower section of the dashboard by pressing the five plastic clips into place.
-
Check the pedal switches and adjust them if necessary.
5. Plug in the pedal position sensor connector and reconnect the vacuum hose.
6. Install the ABS hydraulic unit.