9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
1. Fit a new seal between the heater housing and bulkhead.
2. Fit the heat exchanger in housing Fit housing in position. Make sure that the lower edge of the housing is in its groove.
3. Fit screws to housing.
4. Fit cable entry in position.
5. Fit floor vents.
6. Plug in connectors for servomotor fan motor and blended air sensor (cars with ACC only).
7. Fit the plastic holder securing the wiring harness under the heater housing.
8. Fit the air duct which goes to the rear floor.
9. Fit the defroster vent and defroster air ducts.
10. Suspend the electrical distribution box in position and fit the wiring harness cable tie to the heater housing.
11. Place the combined instrument on the steering column bracket.
