9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
Brake Fluid Pressure Sensor/Switch: Service and Repair
WARNING
-
When carrying out any work on the brake system's hydraulic circuits the system must first be depressurized.
-
Depress the brake pedal about 20 times or until noticeable resistance is felt in the pedal.
-
Before starting any work on the pressure switch, thoroughly clean the area adjacent to it so that the risk of dirt getting into the brake
system is eliminated.
Removal
1. Remove the damping rubber on the pressure pipe.
2. Unplug the connector from the pressure switch.
3. Install an extension piece on special tool (16) 89 96 571 and unscrew the pressure switch.
NOTE: If the pressure switch is tightened down hard, a suitable counter stay can be placed between the pump body and the hydraulic unit.
Installation
