saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Trionic Engine Management - Fault Diagnosis|Page 528 > < Trionic Engine Management - Fault Diagnosis|Page 526
Page 10
background image

4.

The fuel pump relay supplies the fuel pump with power. Therefore, check the operation of the fuel pump relay as follows:

^

turn the ignition switch to the OFF position. Remove fuse 23 for 5 seconds.

^

put fuse 23 back again

^

turn the ignition to the ON position. Listen to check whether the fuel pump is working. The fuel pump should run for about 2 seconds. If it does not,
see "Fault diagnosis, fuel pump relay.

5.

Check the following:

^

as described in point 3, check that the ignition discharge module and injectors are supplied with power from the main relay. It this is not the case,
carry out fault diagnosis on the leads to the injectors, J37, J67, and H24-1. Ignition discharge module H10-7. 

^

check that the ignition discharge module produces spark. If it does not, see Service Manual 2:3 Fuel system and air induction system.

Trionic Engine Management - Fault Diagnosis|Page 528 > < Trionic Engine Management - Fault Diagnosis|Page 526