9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
b. Insert the complete unit, pump/partition plate, while turning it forward and backwards until the Belleville washer for cylinder C is against the
gear case. Then install the unit with two opposite screws.
Tightening torque: 10 Nm (7.3 ft. lbs.)
c. Attach measuring device tool No. 87 91 519, or equivalent, to the turbine shaft.
d. Check that the tip of the dial gauge is against the stator shaft and set the dial gauge to "0".
e. Measure axial play by raising the measuring device.
Correct axial play: 0.1-0.3 mm (0.004-0.012 inch)
f.
If the actual value deviates from the correct value, a thicker or thinner shim should be selected.
-
Lift off the complete unit, pump/partition plate.
4. Install shim holders and the required shim to the partition plate hub.
5. Insert 2nd one-way clutch in the intermediate plates for brake C so that the inner teeth are in contact with the washers.
6. Check that all intermediate plates are engaged in the outer ring of the one-way clutch by turning the outer ring so that the intermediate plates also
move.
7. Slightly tighten the brake band adjusting screw so that cylinder B is fixed.
Then turn the transmission one quarter turn.
8. Install the entire unit (pump, partition plate and 2nd one-way clutch) in the gear case by turning forwards and backwards and pressing in.
NOTE: Make sure that the one-way clutch does not drop out of the plate assembly.
