9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
Throttle Valve Cable/Linkage: Adjustments
Without Traction Control System (TCS)
Adjusting
Adjustment applies to cars with four cylinder engines without Traction Control System.
1
Detach the bellows from the throttle body and move to one side.
2
Depress the throttle arm to kick-down position and insert tool 87 91 980 into the throttle body. The "UP" mark should be aligned against the cast
partition in the throttle body.
3
Undo the stop nut on the kick-down cable and pull the casing until wide open throttle position can be felt. Wide open throttle position is felt just
before the kick-down position.
Note: Some cars have two stop nuts.
4
Tighten the stop nut while holding the casing in wide open throttle position.
5
Depress the throttle arm and remove the tool from the throttle body. Carefully move back the throttle arm.
6
Refit the bellows to the throttle body.