9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
Valve Body: Service and Repair
On Vehicle Service
Valve Body Cover
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Removal
1. Remove the battery.
-
Remove the battery tray and connector.
2. Extract the dipstick.
3. Undo the four screws and remove the valve body cover.
-
Screw size = 10 mm.
4. Remove the gasket from the valve body cover.
Installation
1. Install the gasket to the valve body cover and then install the cover using four screws.
-
Screw size = 10 mm.
Tightening torque: 6 Nm (4.4 ft. lbs.)
2. Insert the dipstick.
3. Install battery tray and battery.
Valve Body
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
