9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
1. Remove the metal cover on one side of the valve body, five screws.
2. Remove the spring and upshift valve 2-3-4.
3. Remove the outer shift valve 1-2.
4. Remove the cover on the underside of the valve body, six screws.
-
Hold your hand against the cover so that it does not fly off as there are several springs inside.
5. Lift out the valves.
-
Place them on the bench in the same order as they are installed in the valve body so that they can be reinstalled correctly.
-
Do not mix up the parts.
-
The following parts are removed:
a. Spacer, 4-3-2 valve
b. Pin, 4-3-2 valve
c. Spring, 4-3-2 valve
d. 4-3-2 valve
e. Spring, lock-up valve 4-3
f.
Lock-up valve 4-3
g. Spring, throttle pressure valve
h. Spring, lock-up valve 2nd
i.
Lock-up valve 2nd
j.
Spring, shift valve 1-2
k. Inner shift valve 1-2
6. Remove the clip and then take out the throttle pressure valve.
Lower Section
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
