9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
30.
Remove the gearbox end cover (13 bolts TORX TX 27) and take off the gasket.
31.
Pry up the flange and undo the 36 mm screw on the pinion shaft. Clean off any chippings on the gear wheel.
Important
The parking detent must be engaged.
32.
Pull off the gear from the pinion shaft.
33.
Heat with a hot-air gun and remove the bearing race to access the governor.
34.
Remove governor stages 1 and 2 (black screws) as well as the spring washer securing the piston for stage 2.
Make sure all moving parts are running freely. Scratches that make moving parts stick must be rectified or the scratched part replaced.
Alternatively, the entire governor can be changed.
35.
Change the spring for stage 2.
36.
Replace stages 2 and 1 (the parts fit in one way only).
Tightening torque 10 Nm (7.4 lbf ft)
